ELECTRICAL COMPONENTS
2
1
b
a
2
1
a. Remove the ignition coil (TCI unit).
b. Connect the digital circuit tester () to the sec-
ondary terminal.
Digital circuit tester (CD732):
90890-03243
Model 88 Multimeter with tachometer:
YU-A1927
• Positive tester probe
High tension cord "1"
• Negative tester probe
Wire "2"
c. Measure the secondary coil resistance.
CHECKING THE ENGINE SWITCH (EQUIPPED
MODELS ONLY)
1.
Check:
• Engine switch continuity
Out of specification Replace.
a. Disconnect the engine switch connectors.
b. Connect the digital circuit tester () to the engine
switch connectors as shown.
Digital circuit tester (CD732):
90890-03243
Model 88 Multimeter with tachometer:
YU-A1927
• Positive tester probe
Terminal "1"
• Negative tester probe
Terminal "2"
c. Check the engine switch continuity.
• Engine switch "RUN"
Continuity "a"
• Engine switch "OFF"
No continuity "b"
CHECKING THE STARTER MOTOR OPERATION
1.
Remove:
• Starter motor
2.
Check:
• Starter motor operation
5-8
1
2
3
4
5
6
7
8
9
10