Table of Contents
Advertisement
Draining
• Regularly check that your standpipe or tub is free from lint or other obstructions, which may affect how your
washer works or may cause flooding.
• In multi-storey apartments or any upper floor, the washer should be installed on a floor equipped with a drain.
• Draining must comply with local by-laws
Water Supply
Your cold water should not exceed 35°C and your hot water should not exceed 65°C. Temperatures
above these may cause the washer to fault or cause damage to the washer.
• If you have an uncontrolled water heating source (eg a wet back or solar heating system) you should fit a
tempering valve. This will ensure the hot water temperature remains within safe limits.
• Contact your registered plumber to select and install the tempering valve.
• Inlet water static pressure: Max. 1MPa (150psi) Min. 34KPa (5psi)
• Inlet water flow rate at tap: Min. 6 litres/min
• This appliance must be installed in accordance with the installation instructions before use.
• Provide accessibility to the plug or incorporate a switch in the fixed wiring in accordance with the
• Do not operate this washer if it has been damaged during transport. Contact your
https://producthelp.fisherpaykel.com/nz/Wash/Top_Loaders/WashSmart/WA70T60GW1/User_Guide_WA70T60GW1/03_Inst...
wiring rules to allow disconnection of the appliance from the supply after installation.
Fisher & Paykel dealer or Fisher & Paykel trained and supported service technician.
Updated: Wed, 20 Jan 2021 23:10:07 GMT
Powered by
5
Advertisement
Table of Contents
