To prevent siphoning the drain hose should not extend more than 20 mm from the end of
the guide. The height of the standpipe or tub should be between 850 – 1200 mm. The drain
hose can be trimmed to length.
3. Place the drain hose in the tub or standpipe. Do not fit the hose to a drain spigot. Drainage must not be airtight
in order to prevent siphoning.
Electrical connection
• This appliance must be supplied with a 220 – 240 V, 50 Hz, sinusoidal, 10 A electrical supply.
• Check the power cord for damage, making sure it is not squashed or twisted.
• A damaged power cord must be replaced by a Fisher & Paykel trained and supported service technician, in
order to avoid a hazard.
• The appliance must not be operated until it is repaired, as there is a risk of electric shock.
Draining
• Regularly check that your standpipe or tub is free from lint or other obstructions, which may affect how your
washer works or may cause flooding.
• In multi-storey apartments or any upper floor, the washer should be installed on a floor equipped with a drain.
• Draining must comply with local by-laws.
Water supply
Your cold water should not exceed 35°C and your hot water should not exceed 65°C.
Temperatures above these may cause the washer to fault or cause damage to the washer.
• If you have an uncontrolled water heating source (eg a wet back or solar heating system) you should fit a
tempering valve. This will ensure the hot water temperature
• remains within safe limits.
• Contact your registered plumber to select and install the tempering valve.
• Inlet water static pressure: Max. 1 MPa (150 psi) Min. 34 KPa (5 psi)
• Inlet water flow rate at tap: Min. 6 litres/min
https://producthelp.fisherpaykel.com/au/Wash/Top_Loaders/FabricSmart/WA8560P1/User_Guide_WA8560P1/03_Installation...
Updated: Wed, 26 Feb 2020 08:47:21 GMT
Powered by
5