Table of Contents
Advertisement
your washer does not have an internal heater to heat water.
Should you wish to use cold water only for all wash cycles, refer to 'Customising the wash cycles' on how to program
your washer to remember your wash preferences.
Levelling Instructions
It is IMPORTANT to level the washer to ensure good spin performance. Note: after levelling, the corners of the washer
should be clear of the floor and the washer must not rock in any direction.
Levelling Your Washer
1. Move the washer to its final position (we suggest a
minimum clearance of 20mm each side).
2. Adjust all four feet (wind down) so the washer is
level and does not rock.
To Check If Your Washer is Level:
1. Look down on the wash bowl and make sure it sits slightly forward of centre (see Diagram 1).
2. Close the lid.
3. Visually check that the lid fits evenly on both sides. If it does not look like the diagram in the middle, adjust one
of the feet slightly until it matches. The diagram on the top and bottom are not correct (see Diagram 2).
Diagram 1
https://producthelp.fisherpaykel.com/nz/Wash/Top_Loaders/WashSmart/WA70T60GW1/User_Guide_WA70T60GW1/03_Inst...
Adjusting the levelling feet
Diagram 2
Updated: Wed, 20 Jan 2021 23:10:07 GMT
Powered by
7
Advertisement
Table of Contents
