Connecting To The Water Supply; Inlet Hoses - Fisher & Paykel WH1060P1 Installation Instructions Manual

spanner provided and wind the feet up or down to correctly
level the machine.
4. Using the spanner provided, tighten the lock nuts against the
base of the washer to lock the feet in position.

Connecting to the water supply

Inlet Hoses

• Use new hose sets provided with the washer to connect the washer to the water mains.
• Old hose sets should not be re-used.
• We recommend the inlet hoses are changed every 5 years.
Failure to do so may result in a flood and damage to property.
1. Connect the straight ends of the inlet hoses to the taps.
2. Connect the elbow ends to the corresponding machine
inlet valves. The hot valve is coloured orange to make
this easier.
3. Tighten the inlet hose ends by hand until the hose seal
just makes contact with the tap sealing face. Continue to
tighten a further half-turn. Make sure there are no kinks
in the hoses.
https://producthelp.fisherpaykel.com/au/Wash/Front_Loaders/WashSmart/WH1060P1/User_Guide_WH1060P1/03_Installatio...
Locking the feet
Updated: Mon, 06 Apr 2020 08:08:16 GMT
Powered by
7