Unitek Miyachi IP-215A User Manual page 96

ALPHABETICAL SUBJECT INDEX
About this manual (1-1)
About your equipment (2-1)
Activating the data output port (5-10)
Adjustment of display viewing angle (7-2)
Alarm messages (E-1)
Assistance (1-3)( 7-3)
Automatic performance monitors (5-7)
Automation capability, general (2-2)
Average pulse width display screen (4-9)
Average pulse width monitoring (5-6)
Battery replacement:
Memory backup (7-2)
Welcard (6-1)
Cable wiring specifications (B-1)
Card identification display screen,
Welcard (6-4)
Card name display screen, Welcard (6-3)
Card type display screen, Welcard (6-3)
Cautions and warnings page (iii)
Clock display screen (4-8)
CLOCK key (4-8)
Connections:
I/O signals (B-1)
Multiple welding transformers (3-
3)
Standard installation (3-2)
Connector functions (B-1)
Constant current feedback mode, general
(2-1)
Constant power feedback mode, general
(2-2)
IP-215A/IP-217A FINE SPOT WELDING POWER SUPPLIES
Index-2
-A-
-B-
-C-
Constant voltage feedback mode, general
2-1)
Contents, table of (v)
Contrast adjustment, display (4-2)(7-2)
Control feedback gain setting (5-9)
Control limit monitor (5-7)
Control mode status indicators (4-4)
Controls:
Front panel (4-3)
Rear panel (4-1)
Copy direction display screen, Welcard
(6-4)
COUNT key (4-10)
Count reset (4-10)
Current setting monitoring (5-6)
Cursor keys (4-9)
DATA -DOWN/UP+ key
Data I/O connector (4-2)
Data output port activation (5-10)
Data records, Welcard (6-2)
Dimensions, installation (3-1)
Directory referencing, Welcard (6-3)
Display contrast adjustment (4-2)(7-2)
Display data entry ranges (5-2)
Display, liquid crystal (4-2)
Display screen editing (5-1)
Display screens:
Average pulse width (4-9)
Clock (4-8)
Mode selection (4-5)
Mode selection extension (4-6)(5-
8)
Monitor limits (4-7)
Welcard card name (6-3)
Welcard card type (6-3)
Weld heat (4-8)
Weld schedule (4-5)(5-3)
993-603 REV A: October, 1996
-D-