Referencing The Directory - Unitek Miyachi IP-215A User Manual

1. Press the COPY and FILE keys simultaneously. The display screen will indicate a
CARD CLEAR message and request CARD TYPE? (1-3).
2. Press the DATA keys to select the Welcard type, as follows:
Schedule Welcard:
Monitor 1 Welcard:
Monitor 2 Welcard:
Note: Functions 1 and 2 require special software and a card reader.
3. Press the ENTRY key. The display
screen will ask you to confirm that
you wish to initialize the selected
Welcard type.
4. With the CURSOR keys, move the
cursor to YES and press the ENTRY
key to confirm that you wish to
initialize the selected Welcard type. If you enter NO, the program will return to step
1.
5. Shortly following your YES
confirmation, the display screen
will automatically request that you
confirm that you wish to enter the
Welcard name. With the CURSOR
keys, move the cursor to YES and
press the ENTRY key to access the
Welcard Name display screen. (If you enter NO, the program will bypass the
Welcard name designation and complete initialization of the Welcard without naming
it.)
6. With the CURSOR and DATA keys, key in up to eight characters as an identifying
name and press the ENTRY key to complete initialization of the Welcard.
7. Remove the Welcard from the Welcard drive.
Referencing the Directory. This function displays the name of the Welcard set
during the initialization operation. For a schedule Welcard, the recording status will be
displayed, and you can set write protection ON and OFF. To reference the directory:
IP-215A/IP-217A FINE SPOT WELDING POWER SUPPLIES
993-603 REV A: October, 1996
CHAPTER 6: USING THE WELCARD
1
2
3
6-3