Unitek Miyachi IP-215A User Manual page 4

IS USED IN THE OPERATION OF THIS EQUIPMENT
MAY RESULT IF PERSONNEL FAIL TO OBSERVE THE SAFETY PRE-
CAUTIONS LABELED ON THE EQUIPMENT AND NOTED ON THIS PAGE
Only a qualified technician should be allowed to work inside the unit.
Never work on electronic equipment unless there is another person
nearby who is familiar with the operation and hazards on the
equipment and who is competent in administering first aid. The
technician who is aided by operators must warn them about the
hazards.
Whenever possible, shut off the power supply to the equipment
before beginning work on it. When you have shut off power, ground
all parts. Be sure to discharge every capacitor that may hold a
dangerous potential to ground when working inside the equipment.
Do not touch high-voltage connections or 208/230 volt input
connections when installing or operating the equipment. WARNING:
Do not be misled by the term low voltage. Potentials as low as
50 volts may cause death under adverse conditions.
PLEASE READ THE SAFETY STEPS ON THE NEXT PAGE
IP-215A/IP-217A FINE SPOT WELDING POWER SUPPLIES
iv
CAUTIONS
AND
WARNINGS
HIGH VOLTAGE
DEATH ON CONTACT
993-603 REV A: October, 1996