Table of Contents
Advertisement
Space Requirements
We recommend that you install the Power Supply and its supporting equipment in a well venti-
lated area that is free from excessive dirt and moisture. Other installation considerations are:
The work surfaces must be level, stable, free from vibration, and capable of
supporting the combined weight of the total welding system. The weight of the Power
Supply is:
215 Power Supply
217 Power Supply
Allow ample work space around the Power Supply so that it will not be jostled or
struck while welding. The dimensions of the Power Supply are:
215 Power Supply
mm
217 Power Supply
mm
The atmosphere is free of chemical vapors and particles, and a space of at least 10 cm
(4 in.) is maintained behind the Power Supply for ventilation and air flow.
The Power Supply is far enough from the weld head to avoid contact with weld
splash.
There are no sources of high-frequency energy close by.
NOTE: Be sure that all accessories that you ordered and all items
listed in the shipping kit (see Equipment Description in Chapter 2)
are available, and that the Power Supply shows no sign of damage.
Standard Installation
The standard Power Supply/Welding Transformer installation is shown in Figure 3-1. Depending
on your welding application, you will require an appropriate welding transformer (see Appendix
C).
IP-215A/217A FINE SPOT WELDING POWER SUPPLIES
993-603 REV A: October, 1996
CHAPTER 3
GETTING STARTED
10 Kg (22 lb)
13 Kg (28.6 lb)
269 mm (10.5 in.) high, 142 mm (5.5 in.) wide, and 436
(17.2 in.) deep
269 mm (10.5 in.) high, 172 mm (6.8 in.) wide, and 466
(18.3 in.) deep
3-1
Advertisement
Table of Contents
