Cleaning Honeycomb Assemblies; Removing Interior Back Panels; Cleaning Under Merchandisers - Hussmann IMPACT Elite E1 Installation And Operation Manual

5-2 M
AINTENANCE

CLEANING HONEYCOMB ASSEMBLIES

Honeycombs should be cleaned every six months.
Dirty honeycombs will cause merchandisers to
perform poorly. The honeycombs may be cleaned
with a vacuum cleaner. Soap and water may be
used if all water is removed from the honeycomb
cells before replacing. Be careful not to damage
the honeycombs.
1. Using a flat object such as a screw driver,
compress the honeycomb and remove it
from its retainer.
2. Clean and dry the honeycomb.
3. After cleaning, replace in reverse order.
Honeycomb
Retainer
Multi-deck Honeycomb Replacement
Honeycomb
Single Deck Honeycomb Replacement
P/N 0453523

REMOVING INTERIOR BACK PANELS

The interior back panels may be removed for
cleaning and to gain access to the evaporator
coils. Remove the rear interior back panels as
follows:
1. D
2. Remove shelving.
3. Remove the lower panel first: lift the panel
4. Remove the top panel.
5. Replace panels in reverse order, starting with
6. After cleaning or servicing the merchandiser,
Retainer

CLEANING UNDER MERCHANDISERS

Remove lower front panels. Use a vacuum with a
long wand attachment to remove accumulated
dust and debris from under the merchandiser.
ISCONNECT THE ELECTRICAL POWER TO THE
.
MERCHANDISER
up, then pull forward and out.
the top panel.
reconnect the electrical power.