Hussmann IMPACT Elite E1 Installation And Operation Manual page 6

1-4 I
NSTALLATION
Insert Alignment Rod and Pins
1. Insert the alignment rod into the right end of
the left case as indicated in the detail below.
Verify alignment pins are properly seated in
the left case.
Canopy
Alignment
Rod
Apply Gaskets
1
1. Apply / in. (13 mm) gasket in the recess
2
across the bottom and up the front of the
merchandiser as shown. Gasket should cover
slots.
5
/
2. Apply the 1 in. (41 mm) gasket to cover
8
foam-to-metal gap at rear of case and across
the top as shown. Be sure to lap gaskets as
shown. Check to be sure that there are no
gaps between gasket and merchandiser.
Fasten Cases
1. Move the second merchandiser into position
against the first. Match the alignment rod
and pin with the corresponding holes.
2. Fasten fronts together using cap screws, flat
washers, lock washers and nuts. Tighten
only until front panels touch. Do not tighten
fully.
3. Use the cap screws, flat washers and lock
washers provided in the joint kit to draw
the merchandisers together at rear. Do not
tighten fully.
4. Tighten joints in the order shown (A, B, C,
D, E) until gaskets are compressed, and
cases join smoothly.
P/N 0453523
1 1
/ x / Inch Gasket
2 2
5 1
1 / x / Inch Gasket
8 2
Alignment Pin
A
IMPORTANT
• Do not stretch gasket,
especially around corners.
• Do not butt gaskets;
always lap them as shown.
• Remove paper backing
after gasket has been applied.
Tighten in Order Shown
Alignment Pin
1 1
/ x
2
5
1 /
8
A
E
/ Inch Gasket
2
1
x / Inch Gasket
2
D
C
B
C
B