Table of Contents
Advertisement
4-2
S
TART UP
Discharge Air
Honeycomb
Load Limit
MULTI-DECK SHELF ALIGNMENT
Taped to one of the shelves of each merchandiser
is a small plastic bag containing shelf alignment
strips. These strips are designed to enhance the
appearance of the shelves by aligning the front
edge of each shelf with that of an adjacent shelf.
When installing shelves:
1. Insert one of the alignment strips into the slot
behind the front edge of each shelf.
5
(
/
8
P/N 0453523
/ O
PERATION
Shelf Alignment Strip
x 6-inch — 16 x 32 mm )
2. After all shelves are installed, slide the strip
across the shelf joint wherever two shelves
are adjacent. This will lock them together.
MULTI-DECK SHELF CONFIGURATION
The bottom display shelves can be adjusted to
accommodate shallow or volume displays
(bulky items such as hams or chickens). The
upper shelves are individually mounted in 1 in.
(25 mm) increments and have two-position brack-
ets permitting shelves to be placed in a flat or
down-tilt position (see illustration). Front product
stops are recommended when shelves are placed
in the down-tilt position.
Refer to each model's data sheet for specific
shelf configuration.
PROCEDURE FOR INSTALLING LIGHTED
SHELVES WITH SINGLE-PRONG
CONNECTOR
Shelf lighting uses parallel
wiring. Please follow these
instructions to ensure good
contact between male and
female connectors.
1. SHUT OFF POWER TO CASE. REMOVE
ALL SHELVES.
Advertisement
Table of Contents
