Program The Firmware; Program System Images Using Fastboot - Thundercomm TurboX C610 Open Kit User Manual

Hide thumbs Also See for TurboX C610 Open Kit:

Table of Contents

Thundercomm TurboX C610 Open Kit

2 Program the Firmware

The following method is the recommended procedure for downloading your

experimental version of self-compiled OS on C610. A host PC is needed to

program the board.

The procedure for both Windows and Linux host systems is described.

Ensure you have installed the required ADB and Fastboot drivers. Your board

NOTE:

must be detected on your host machine.

To install Linux from a host PC complete the following steps:

Download the C610 fastboot images package from the Thundercomm website

and unzip it.

2. Entering to Fastboot

a. Press and hold 'VOL-' then press Power once quickly to force the device

to enter Fastboot mode

b. Alternatively "adb reboot bootloader" from the command prompt.

3. Plug the USB cable into the Device

4. Confirm that Fastboot is active as follows:

a. From the Windows command shell, run:

fastboot devices

dae93bbb

b. From Linux, run:

$sudo fastboot devices

dae93bbb

Rev. 1.0

MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION

"QCS610 USB 0"

fastboot

Table of Contents

Do you have a question about the TurboX C610 Open Kit and is the answer not in the manual?