ADF Web SNMP Agent / CANopen User Manual page 17

Industrial Electronic Devices
In the field "Network Start at
Operational State of all the devices present in the network, after the time defined in the "Delay" field;
In the field "Delay (s)" the delay before sending the "Start" command for the CANopen is defined;
In the field "SDO Client TimeOut (1/10
interrogated is defined;
If the field "Enable Sync
network;
If the field "Enable Restart CANopen
"ReStart Devices" that are not answering to the NodeGuarding;
If the field "Enable Reset
to NodeGuarding;
If the field "Enable Triggered
starting input byte of the converter to write for sending the SDO requests is defined in the field
the response is saved starting from output byte defined in the field
In the field "Heartbeat Time
ADFweb.com Srl – IT31010 – Mareno – Treviso
Start-Up" the state of the CANopen network is defined. I.e. If it is checked the board sends a command to set the
ms)" the maximum time that the device attends for the answer from the Slave
(ms)" is checked and a time is defined, the converter can send cyclically a SYNC message to the CANopen
Devices" is checked, the converter restarts the CANopen devices listed in the section
Data" is checked, the converter resets data on SNMP side for the CANopen devices that are not answering
SDO" is checked, the it is possible to send asynchronous SDO requests directly from SNMP side. The
(ms)" the delay between Heartbeat messages is defined.
User Manual SNMP Agent / CANopen
Document code: MN67156_ENG
"Address Output Data TDSO". See page 35 for more info;
INFO: www.adfweb.com
Revision 1.100 Pagina 17 di 40
"Address Input Data TSDO" and
Phone +39.0438.30.91.31