NEC PG-FP4 User Manual page 87

CHAPTER 6 PG-FP4 OPERATION IN STANDALONE MODE
[Prog Area]
Displays the valid memory area specified in the 2 MB user program area of the PG-FP4 as
either of the following.
on (0): User program Area 0 (0x00000000 to 0x000FFFFF) is specified.
on (1): User program Area 1 (0x00100000 to 0x001FFFFF) is specified.
off:
Display example
↓ Next button
[Chip ERS dis.]
Displays the set status of Disable Chip Erase of Security flag settings as either of the
following
on: The Erase command is invalidated on the entire flash memory area of the target
off: The Erase command is executable.
↓ Next button
[Block ERS dis.] Displays the set status of Disable Erase block of Security flag settings as either of the
following
on: The Erase command is invalidated for a selected block in the flash memory of the
off: The Erase command is executable.
↓ Next button
[Block PRG dis.] Displays the set status of Disable Program Block of Security settings as either of the
following
on: The Program command is invalidated for a selected block in the flash memory of the
off: The Program command is executable.
↓ Next button
[dis. PRG Blk >] When the Enter button is pressed next, all the blocks prohibited from being programmed are
listed
Display example
↓ Next button
[dis. ERS Blk >] When the Enter button is pressed next, all the blocks prohibited from being erased are
listed
Display example
Note This menu is displayed only when a single-power-supply flash memory microcontroller is used.
Entire 2 MB user program area is specified.
Prog Area
on (0)
Note
.
device.
Note
.
target device.
Note
.
target device.
Note
.
00, 01, 02, 04, 05 (Blocks 0, 1, 2, 4, and 5 are prohibited from being programmed.)
Note
.
00, 01, 02, 04, 05 (Blocks 0, 1, 2, 4, and 5 are prohibited from being erased.)
User's Manual U15260EJ3V1UM
87