NEC PG-FP4 User Manual page 64

CHAPTER 4 PG-FP4 OPERATION USING GUI SOFTWARE
<4> Operation Mode
Operation Mode may divide the flash memory of the target device into blocks or areas.
This menu is used to select the operation mode of the flash memory. Some devices do not have either or
both division modes Block and Area. In this case, a mode that is not available cannot be selected.
Figure 4-25. Setup Window – Operation Mode
[When Chip is selected]
The entire flash memory area of the target device is subject to rewrite processing.
[When Block is selected]
Specify the Block number range subject to rewrite processing by using Start/End.
The Start/End list boxes display the Block number where the flash memory of the target device is configured.
(Block cannot be selected with a two-power-supply flash memory microcontroller.)
[When Area is selected]
Specify the Area number range subject to rewrite processing by using Start/End.
The Start/End list boxes display the Area number where the flash memory of the target device is configured.
(Area cannot be selected with a single-power-supply flash memory microcontroller.)
[Show Address check box]
Specifies whether numbers or addresses are displayed in the Start/End list boxes.
If this check box is checked, addresses are displayed.
If it is not checked, numbers are displayed.
[Selective programming]
This cannot be used.
64
User's Manual U15260EJ3V1UM