NEC PG-FP4 User Manual page 112

No.
E 210 Line too long.
E 211 Nested repeat is not supported.
E 212 Loop number invalid.
E 213 File too long.
E 214 Statement 'repeat <num. rep.>' missing.
E 215 Command not found
E 216 Download file name missing.
E 217 Opening download file failed.
E 218 Upload file name missing.
E 219 Opening parameter file for upload failed.
E 220 Opening upload file failed.
E 221 Command not allowed in script file.
E 222 Processing a command failed.
E 223 Command execution failed.
E 300 Determining download directory failed.
E 301 Determining upload directory failed.
E 302 Trying to open USB port failed.
E 303 Trying to connect Programmer failed.
E 304 Trying to open serial port failed.
E 305 Changing the communication speed of the
programmer failed.
E 306 Trying to connect Programmer failed.
E 307 Trying to open USB failed.
E 316 Trying to connect Programmer failed.
E 317 ver command failed.
E 400 Port is already open.
E 401 The communication port has not been opened so
far.
E 500 Evaluating CRC answer failed.
E 501 Operation failed.
E 502 Programmer is not responding.
E 503 Receiving failed.
E 600 Appending information to communication logging
file failed.
112
CHAPTER 10 ERROR MESSAGES
Message
User's Manual U15260EJ3V1UM
Description
Executing a script file might abort with one of these errors.
The contents of the line causing the error are also
displayed.
The script syntax was correct and the command has been
sent to the PG-FP4, but the command execution itself
showed an error (e.g. a verify error on the target device).
The selected directory name in the file download dialog
box is invalid.
The selected directory name in the file upload dialog box is
invalid.
The processing after setting the Programmer
Communication Setup dialog box might fail due to one of
these reasons. Please verify proper selection of the
port/speed for the programmer.
Executing the ver command failed.
Processing after setting the Programmer Communication
Setup dialog box failed since the port is already open.
Check if programmer ports are set correctly.
Sending a command to the PG-FP4 is only possible after
the communication channel has been opened.
The PG-FP4 answered with an unexpected string after
sending the Checksum command.
Executing a command failed (e.g. a verify error occurred for
a signal from the target device).
Communication between the PC and the PG-FP4 timed out.
Reading the PC port failed.
Writing data to the communication log file failed.