Table of Contents
Advertisement
Page
Throughout
Change of URL of NEC Electronics Corporation.
pp.18 to 21
CHAPTER 2 HARDWARE INSTALLATION
• • • • Addition of operating software Windouws 2000 and Windows XP
p.18
2.1 System Requirements
• • • • Change from "PC-9821 series" to "PC-9800 series"
p.20
2.3.2 PG-FP4 control panel and connectors
• • • • Change of status LED color from yellow to orange
pp.22 to 23
Addition of 2.3.9 I
pp.27, 31 to 33
3.1.1 GUI software installation
• • • • Change of Figure 3-6 Software License Agreement Window
• • • • Change of Figure 3-12 Setup Is Complete Window
• • • • Change of name of file to be installed.
p.33
Addition of 3.1.2 USB driver installation
p.38
3.1.3 GUI software uninstallation
• • • • Addition of (2) uninstallation using "Add/Remove Programs"
p.39
3.2 Firmware and GUI Software Update Installation
• • • • Addition of procedures to update firmware
p.43
Change of Figure 4-3 GUI Software Main Window
Addition of [Programmer] − [Select Programming area...] button to Table 4-1 Toolbar Buttons
p.44
pp.52 to 54
4.4.2 [Programmer] menu
• • • • Addition of icon to (3) [Select Programming area...] menu
• • • • Addition of (5) [Update Firmware] menu
pp.55 to 71
4.4.3 [Device] menu
• • • • Change of Figure 4-19 [Device] menu
• • • • (2) to (7) Addition and change of description
• • • • (9) (b) to (c) Addition and change of description
p.70
Change of Figure 4-32 About Window
pp.72 to 81
CHAPTER 5 SAMPLE PROGRAMMING SESSION USING GUI SOFTWARE
• • • • (4) to (8) Addition and change of description
pp.83, 84, 89
CHAPTER 6 PG-FP4 OPERATION IN STANDALONE MODE
• • • • Change of status LED color from yellow to orange
• • • • 6.1.1 [Commands] menu Addition to Note and addition of Note 3
• • • • 6.1.5 [Utilitiy/Misc.] menu Addition of [PRM File Version] and [HEX File Name]
pp.90 to 94
CHAPTER 7 CONNECTORS AND CABLES
• • • • Addition of description about power supply connector, HD-Sub 9 serial host connector, HD-Sub 15 target
interface connector and HD-Sub 25 parallel host connector.
• • • • Change of 7.4 Target Cable Specifications
pp.97 to 100
CHAPTER 8 NOTES ON TARGET SYSTEMS
• • • • Change of example of correct connection regarding RESET signal
• • • • Addition of description about V
• • • • Addition of examples of UART and SIO interface circuits
6
MAJOR REVISIONS IN THIS EDITION (1/2)
2
C adapter
PP
The mark
shows major revised points.
User's Manual U15260EJ3V1UM
Contents
Advertisement
Table of Contents
