Table of Contents
Advertisement
[Vdd [V]]
Displays the default Vdd level set by the parameter file in volts (V).
This Vdd level can be changed by input.
[Vdd2 [V]]
Displays the default Vdd2 level set by the parameter file in volts (V).
If the specifications of the target device require two types of Vdd for writing the flash memory, Vdd2 specifies
a low-level signal voltage. This voltage level can also be changed by input.
[On Target check box]
Check On Target if the V
Caution Set the values of the V
[V] before checking On Target. The target system may be damaged if proper values are not
set.
[Vpp, Clk, Serial Port, Reset, H/S Input]
Display the default level of each pin set by the parameter file in volts (V).
The signal levels cannot be changed.
66
CHAPTER 4 PG-FP4 OPERATION USING GUI SOFTWARE
Figure 4-27. Setup Window – Supply Voltage
/V
voltages are supplied from the target system.
DD
DD2
/V
voltages supplied by the target system as Vdd [V] and Vdd2
DD
DD2
User's Manual U15260EJ3V1UM
Advertisement
Table of Contents
