NEC PG-FP4 User Manual page 52

(2) [Logging] menu
The [Logging] menu opens the log file dialog box to select the log file name. The log file will store the
communication between the PC and the PG-FP4 (data in the communication log window).
Once logging is enabled, a check mark in the [Logging] menu indicates that logging is active.
Selecting the menu again will close the log file and stop any further communication logging.
(3) [Select Programming area...] menu
This menu item allows selection of one out of two different programming areas of the PG-FP4 (1 MB
each). This menu is valid when "Enable two Program Areas" on the Advanced tab of [Device] >
[Setup] menu is checked.
The PG-FP4 internal memory area is split into two independent memory areas of 1 MB, each of which may
hold two different application programs for flash programming. When opening this dialog box, the current
programming area selection will be displayed.
(4) [Reset] menu
By clicking this menu item, you can execute a software reset of the programmer. The communication window
will show the current version of the PG-FP4 firmware after the reset.
52
CHAPTER 4 PG-FP4 OPERATION USING GUI SOFTWARE
Figure 4-13. <Log File> Dialog Box
Figure 4-14. Programming Area Selection
User's Manual U15260EJ3V1UM