NEC PowerMate ES SlimLine Series Configuration

409-00065-000 4/19/00 3:01 PM
PowerMate ® ES SlimLine Series System Board Configuration
Jumper Settings
Keyboard Factory setting. Wakes up the system from
JKBV1
Wakeup Suspend to RAM mode via the keyboard.
Requires Windows 98 running in Advanced
3 2 1
Configuration Power Interface (ACPI) mode.
JKBV1
Normal operation.
Disables Keyboard Wakeup.
3 2 1
JP3
Onboard Factory setting. Enables onboard audio.
Audio 1 2 3
JP3
Disables onboard audio. Use this
setting if you install a sound card.
1 2 3
JBAT1
CMOS Factory setting. Maintains system board
3
Clear 2 configuration in CMOS RAM
1
with onboard battery.
JBAT1
Clears CMOS while system power is off.
3
Return jumper to pins 1 and 2 before
2
1
powering system on.
Caution: To prevent damage to the system board,
avoid clearing CMOS while power is on.
J4
BIOS Factory setting. Sets the system for
Recovery normal operation. The BIOS uses current
1 2 3
configuration information and passwords
at power on.
To enable BIOS recovery for a corrupted
system, remove the jumper. Wait 10 seconds.
Replace the jumper on pins 1 and 2.
J4
Restores Safe BIOS settings as the
default BIOS settings and loads the
1 2 3
BIOS Setup at power on.
J23
CPU Factory setting.
3
Type 2 Uses an Intel
1
Save to JP4 Factory setting. Enables the
RAM Save to RAM function.
JP4
Disables the Save to RAM function.
Website: www.nec-computers.com
Technical Support: 800-632-4525
Page 1
J23
Uses a Cyrix ® CPU.
3
® CPU. 2
1
Note: See your PowerMate ES SlimLine Series User's
Guide for detailed option installation information.
Memory Upgrade
Maximum memory supported: 512 MB;
minimum memory required: 32 MB.
Memory type and size can vary between sockets.
System supports 168-pin, 100-MHz non-ECC SDRAM modules
in 32-MB, 64-MB, 128-MB, and 256-MB configurations.
Use NEC memory upgrade kits for the best compatibility with your
system. For memory compatibility information, call Technical Support.
Single- or double-sided DIMMS are supported.
No jumper setting required.
Processor Upgrade
See your user's guide for detailed processor upgrade information.
Secondary
JKBV1
Jumper IDE Connector
JP3 J4
Jumper Jumper
JBAT1 Processor Socket
Jumper
(Socket 370)
Primary
IDE Connector
JP4
Jumper
System
J23
Memory
Jumper
Upgrade
Sockets
409-00065-000