Charging USB devices with USB Type A output
CAUTION!
Ensure that the power consumption of the USB device is not
higher than 1 A. For more information, refer to the instruction
manual of your USB device.
Replacing the battery
CAUTION!
Use CR2032 battery types only. Failure to observe this advice
may result in damage to the product.
Open the Battery compartment
anticlockwise with a small phillips screwdriver (not included)
then pull out the Battery compartment cover.
Replace with a new 3 V type CR2032 battery. The marking
"+" must face upwards.
Close the Battery compartment
the screw clockwise with a small phillips screwdriver.
NOTE: Saved data will be lost when changing battery
without connecting the power supply unit.
Basic settings (see fig.B)
Press and hold the MODE button
The hour flashes on the time display
Press the Up button
hour value. Pressing the MODE button
setting. The minute flashes on the time display
TIP: Pressing and holding the Up button
will quickly scan ahead or back through the numbers.
13
NOTE: When no buttons are pressed for approx.
15 seconds the clock will return to standard mode.
Briefly pressing the MODE button
and switch to the next option in the clock settings.
18 GB/IE/NI
7
7
12
or the Down button
11
12
by turning the screw
and tighten it by turning
for around 3 seconds.
.
8
to adjust the
13
will confirm the
12
8
.
11
or the Down button
will confirm the setting
4