USB charger operation:
Plug the USB type A plug of the USB cable into the USB port
on a suitable USB adapter (both not included) and plug the
USB type C plug into connector socket for USB Type C input
3
of the product.
Plug the USB adapter into an easily accessible mains socket.
LED indicator
the product is under standby mode.
Place the mobile device on the Qi charging surface
Make sure the center of the device is aligned over the center
of the Qi charging surface. The Charging process starts once
the mobile device is correctly placed. The LED indicator
lights up blue when charging is active.
Protective covers of the mobile device may interfere with the
charging process. In this case, the mobile device must be
removed from the protective cover.
NOTE: The charging power is up to 10 W, depending on
the power adapter used.
The product only supports devices with Qi wireless technology.
LED indicator
The product uses an LED indicator to show the operating status:
LED indicator
Blue lights up two seconds Starting process (Boot phase) /
Blue lights up
Blue is flashing
will light up for approx. two seconds when
15
status
15
Status
Standby
Charging/
Full Charge
Fault condition
.
1
15
GB/IE/NI
17