Table of Contents
Advertisement
6 Basic Operation
◆
Example: Basic Operation
The following procedures are examples of drive operation using the LCD Operator Option.
Note: Actual LCD display data can vary based on drive parameter settings.
Procedure Example: RUN/STOP
■
Note:
If b1-01 is not set to 0 (Operator), press
1. Apply main power to the drive. The Frequency Reference appears after
the initial display on the LCD Operator Option.
2. Press
to show the Frequency Reference display.
If b1-01 is not set to 0 (Operator), press
3. Press
F1
reference changes to 006.00 Hz.
4. Press
to set the output frequency.
26
Procedure
F2
YASKAWA TOBP C730600 29A V1000 Option LCD Operator Installation Manual
LO
to set LOCAL.
RE
LO
to set LOCAL.
RE
until the frequency
LCD Display
- MODE -
DRV
Rdy
FREF (OPR)
U1-01= 0.00Hz
U1-02= 0.00Hz
LSEQ
U1-03= 0.00A
LREF
JOG
FWD/REV
FWD
-MONITR-
DRV
Rdy
FREF (d1-01)
U1-01= 000.00Hz
0.00 60.00
0.00Hz
←
→
FWD
-MONITR-
DRV
Rdy
FREF (d1-01)
U1-01= 006.00Hz
0.00 60.00
0.00Hz
←
→
FWD
Entry Accepted
Advertisement
Table of Contents
