Create A Contact - Axis I8016-LVE User Manual

AXIS I8016-LVE Network Video Intercom
Configure your device
In this device, VoIP is enabled through the SIP protocol. For more information about SIP, see Session Initiation Protocol (SIP) on page 11
There are two types of setups for SIP. A PBX server is one of them. Use a PBX server when the communication should be between an
infinite number of user agents within and outside the IP network. Additional features could be added to the setup depending on the
PBX provider. For more information, see Private Branch Exchange (PBX) on page 12.
1. Request the following information from your PBX provider:
- User ID
- Domain
- Password
- Authentication ID
- Caller ID
- Registrar
- RTP start port
2. Go to System > SIP > SIP accounts and click + Account.
3. Enter a Name for the account.
4. Select Registered.
5. Select a transport mode.
6. Add the account information from the PBX provider.
7. Click Save.
8. Set up the SIP settings in the same way as for peer-to-peer, see Set up direct SIP (P2P) on page 7 . Use the RTP start
port from the PBX provider.

Create a contact

This example explains how to create a new contact in the contact list. Before you start, enable SIP in System > SIP.
To create a new contact:
1. Go to Contact list.
2. Click + Add contact.
3. Enter the first and last name of the contact.
4. Enter the contact's SIP address.
Note
For information about SIP addresses, see Session Initiation Protocol (SIP) on page 11 .
5. Select the SIP account to call from.
6. Choose the contact's Availability. If a call is attempted when the contact is not available, the call is canceled unless a
there's a fallback contact.
Note
Availability options are defined in System > Events > Schedules.
7. In Fallback, select None.
8