Configure The Call Button; Use Dtmf To Unlock The Door For A Visitor - Axis I8016-LVE User Manual

AXIS I8016-LVE Network Video Intercom
Configure your device
Note
A fallback is a contact, to whom the call is forwarded if the original contact does not reply.
8. Click Save.

Configure the call button

By default, the call button is configured to make VMS (Video Management System) calls. If you want to keep this configuration, you
just need to add the Axis intercom to the VMS.
This example explains how to set up the system to call a contact in the contact list when a visitor presses the call button.
1. Go to Call button.
2. Turn off Make calls in the video management system (VMS).
3. Under Recipients, select a contact.
To disable the call button, turn off Enable call button.

Use DTMF to unlock the door for a visitor

When a visitor makes a call from the intercom, the person who answers can use the Dual-Tone Multi-Frequency signaling (DTMF)
of his SIP device to unlock the door. The door controller unlocks and locks the door.
This example explains how to:
• define the DTMF signal in the intercom
• set up the intercom to:
- request the door controller to unlock the door, or
- unlock the door using the internal relay.
You make all settings in the intercom's webpage.
Before you start
• Allow SIP calls from the device and set up a SIP account. See Set up direct SIP (P2P) on page 7 and Set up SIP through
a server (PBX) on page 7 .
Define the DTMF signal in the intercom
1. Go to System > SIP > SIP accounts and locate the SIP account.
2. Click
3. Click DTMF.
4. Click + DTMF sequence.
5. In the Sequence field, enter "1".
6. In the Description field, enter "Unlock door".
7. Click Save.
Set up the intercom to unlock the door using the internal relay
1. Follow the steps under Define the DTMF signal in the intercom
> Edit.
9