Set Up Sip Through A Server (Pbx); Create An Organization; Create A Contact - Axis I8016-LVE User Manual

AXIS I8016-LVE Network Video Intercom
Additional settings

Set up SIP through a server (PBX)

VoIP (Voice over IP) is a group of technologies that enables voice and multimedia communication over IP networks. For more,
see Voice over IP (VoIP) on page 12.
In this product VoIP is enabled through the SIP protocol. For more information about SIP, see Session Initiation Protocol (SIP) on
page 13
There are two types of setups for SIP. A PBX-server is one of them. Use a PBX-server when the communication should be between an
infinite number of user agents within and outside the IP network. Additional features could be added to the setup depending on the
PBX-provider. For more information see, Private Branch Exchange (PBX) on page 13.
1. Request the following information from your PBX provider:
- User ID
- Domain
- Password
- Authentication ID
- Caller ID
- Registrar
- RTP start port
2. Go to VoIP > SIP accounts > Create account.
3. Enter a Name for the account.
4. Select Registrar.
5. Select a transport mode.
6. Add the account information from the PBX provider.
7. Click Save.
8. Set up the SIP settings the same way as for peer-to-peer. See Set up direct SIP (P2P) on page 7 for more information.

Create an organization

Note
Every contact in the phone book must belong to an organization.
1. Go to VoIP > Phone book > Contacts.
2. Click New.
3. Enter a name and description of the organization.
4. Click Save.

Create a contact

This example explains how to create a new contact in the phone book. This contact:
• has a SIP address
• belongs to an organization
8