Without Transponder Immobilizer - Directed Directechs DB3 Installation Manual

Without Transponder Immobilizer

Ensure vehicle is in a safe location and cannot move forward during programming. For
1
vehicles equipped with a manual transmission, make sure the gearshift is in the neutral
position.
The harnesses must be connected in this exact order:
a) Connect the 14-pin.
2
b) Connect the 12-pin.
c) Connect the 10-pin.
When the LED turns on solid red, proceed with the next step.
Insert and turn the key to the ON position.
3
The LED starts flashing orange quickly.
When the LED flashes red once, press on the programming button 5 times.
The LED flashes orange slowly.
4
Note: Depending on your vehicle, it may take up to 4 minutes to complete programming.
5
When the LED flashes red 3 times, press on the programming button 5 times.
6
The LED turns ON solid orange for 3 seconds, then shuts OFF.
7
Turn the key to OFF and remove it from the ignition barrel.
You have successfully completed the module programming sequence.
13
403.HKHT1 3.25 2013 Hyundai Accent
©2022 VOXX•DEI LLC. All rights reserved.