Safety Recommendations - Cisco 124792 User Manual

1.2 Safety Recommendations

Table 1-8
Compliance
Radiated EMC
EMC
Safety
ESD Immunity
RF Immunity
Surge Immunity
Fast Transient/Burst
Immunity
Immunity
ETSI
1
1.2 Safety Recommendations
Any device that uses electricity requires proper guidelines to ensure safety.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
•
•
Cisco AC/DC Power System User Guide, R1.0
1-8
Compliance Specifications
Description
EN 61000-6-2, EN 61000-6-3, FCC Part 15 Class B
EN 61000-6-2, EN 61000-6-4
CSA C22-2 No. 60950-1, UL 60950-1 and
IEC60950-1/EN60950-1
EN61000-4-2
EN61000-4-3
IEC/EN61000-4-5
IEC/EN61000-4-4
EN61000-4-2
300-386-TC
The Cisco AC/DC Power System should only be installed or serviced by qualified personnel.
An ESD wrist strap is included to protect sensitive electronics and should be connected to a metal
surface to act as a ground. This ensures that all components have the same charge. An ESD wrist
strap should be used when working with internal components that are installed in the shelf. The wrist
strap connects at the rear of the system shelf as shown in
the ESD wrist strap can be connected to the shelf mounting ears or the controller faceplate thumbscrews.
Chapter 1
Figure 1-8. If rear access is not available,
Introduction
May 2006