Download Print this page

Cisco AIR-PWRINJ1500-2 Installation Instructions Manual

Cisco aironet series power injector.
Hide thumbs
   

Advertisement

Cisco Aironet Series Power Injector
AIR-PWRINJ1500-2= Installation Instructions
Last Updated: June 30, 2015
This document describes the Cisco Aironet Series Access Point Power Injector AIR-PWRINJ1500-2=
(referred to as the power injector in this document) and provides instructions for mounting it. The power
injector increases wireless LAN deployment flexibility of the access point by combining 56-VDC power
with the data signal, and sending both to the connected access point.
The following information is provided in this document:
Overview, page 4
Cisco Systems, Inc.
www.cisco.com

Advertisement

   Related Manuals for Cisco AIR-PWRINJ1500-2

   Summary of Contents for Cisco AIR-PWRINJ1500-2

  • Page 1: Table Of Contents

    AIR-PWRINJ1500-2= Installation Instructions Last Updated: June 30, 2015 This document describes the Cisco Aironet Series Access Point Power Injector AIR-PWRINJ1500-2= (referred to as the power injector in this document) and provides instructions for mounting it. The power injector increases wireless LAN deployment flexibility of the access point by combining 56-VDC power with the data signal, and sending both to the connected access point.

  • Page 2: Technical Specifications

    The equipment described in this manual generates and may radiate radio-frequency energy. If it is not installed in accordance with Cisco’s installation instructions, it may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in part 15 of the FCC rules.

  • Page 3: Safety Precautions

    You can determine whether your equipment is causing interference by turning it off. If the interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures: Turn the television or radio antenna until the interference stops.

  • Page 4: Overview

    The power injector’s AC power receptacle connects an approved AC power cord to a wall outlet or power strip. The power injector can be mounted on most horizontal and vertical surfaces, but must be mounted in a vertical orientation to comply with safety requirements. Cisco Aironet Series Power Injector AIR-PWRINJ1500-2= Installation Instructions...

  • Page 5: Unpacking The Power Injector

    An AC line cord • This guide If any item is missing or damaged, contact your Cisco representative or reseller. To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement 1023 Warning You must use shielded outdoor rated Ethernet cable with this device.

  • Page 6: Mounting The Power Injector

    Mounting the Power Injector The AIR-PWRINJ1500-2= Power Injector is not suitable for operation in a building’s environmental air Note space and should not be installed in these environments. Ethernet cable from the switch to the power injector must be a shielded CAT5e or higher Ethernet cable.

  • Page 7: Installing The Power Injector

    To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement 1023 Plug the other end of the Ethernet cable into your Ethernet switch, hub, or network. Step 4 Cisco Aironet Series Power Injector AIR-PWRINJ1500-2= Installation Instructions...

  • Page 8: Checking The Power Injector Leds

    RJ-45 pin signals of the power injector input connector (TO SWITCH. Table 1 Power Injector Input Connector (TO SWITCH) Pinouts Pin Number Signal Name Ethernet signal pair (10/100/1000Base-T) Ethernet signal pair 10/100/1000Base-T) Ethernet signal pair (1000Base-T) Cisco Aironet Series Power Injector AIR-PWRINJ1500-2= Installation Instructions...

  • Page 9: Obtaining Documentation, Obtaining Support, And Security Guidelines

    Subscribe to What’s New in Cisco Product Documentation, which lists all new and revised Cisco technical documentation as an RSS feed and delivers content directly to your desktop using a reader application. The RSS feeds are a free service.

  • Page 10

    Cisco Aironet Series Power Injector AIR-PWRINJ1500-2= Installation Instructions...

Comments to this Manuals

Symbols: 0
Latest comments: