Table of Contents
Advertisement
3.2.2 Replace the Controller Tray
Figure 3-3
Removing the Controller Faceplate
Slide the controller tray out and away from the system shelf to access the Alarm Interface Board
Step 3
(Figure 3-3
Remove the Alarm Interface Board DC terminal block
Step 4
controller hardware).
Remove the alarm cable connections
Step 5
the jumper number, label the cables with the appropriate jumper number: J16, J15, J14 (1,2,3), and J14
(4,5,6)/J13 (for the system without an LCD).
•
Cisco AC/DC Power System User Guide, R1.0
3-4
#2).
–J16 terminal block
(Figure 3-4
(Figure 3-4
or
Figure 3-5
#2). If alarm cables are not labeled with
Chapter 3
Component Replacement
or
Figure 3-5
#1, depending on your
May 2006
Advertisement
Table of Contents
