Table of Contents
Advertisement
Chapter 2
System Installation
Figure 2-14
1
Tighten the handle-mounted common screws into the rectifier to ensure a firm connection
Step 6
#2).
Repeat this procedure for any additional modules (two total for small systems, three for medium
Step 7
systems, and four for large systems. Some systems may require removing blank rectifier faceplates. To
do this, remove the two Phillips screws from the blank rectifier faceplate
blank rectifier faceplate mounting bracket by removing the two Phillips screws
May 2006
Installing a Rectifier
2
2.3.1 Install the Rectifiers
(Figure 2-15
(Figure 2-15
Cisco AC/DC Power System User Guide, R1.0
(Figure 2-14
#1). Remove the
#2).
2-17
Advertisement
Table of Contents
