Erase Lamp Replacement - Ricoh FT2050 Field Service Manual

Erase Lamp Replacement (FT2070)
1.
Unplug the copier.
2.
Remove the upper right cover and upper rear
cover.
3. Remove the ac drive board (2 screws).
4.
Uncouple the 8 pin connector behind the ac
drive board.
5. Open the clamshell while pressing down the
release lock.
CAUTION: * Be careful not to damage the slider.
6.
Pull the master release lever and remove the
master unit.
CAUTION: * Do not touch the master belt (purple
material), and avoid exposing it to
light.
NOTE: * When installing the master unit, make
sure that the master rides in the guide
rails.
7. Remove the erase lamp unit by sliding it to the
rear and then to the left (1 screw).
February 1, 1986
5-12-1