Table of Contents
Advertisement
February 1, 1986
29. When not using this instruction booklet, place it in
the holder on the back of the copier.
30. Check machine operation and copy quality.
Fill out the New Equipment Condition Report.
This completes machine installation.
2-8,
Main Transformer Conversion
(220 to 240V only)
1.
Open the top unit and remove the development unit.
2.
Swing up the upper feed guide (1 screw).
Remove the lower feed guide (4 screw).
3.
4.
Uncouple the 220V connector and couple the 240V
connector.
5.
Remove the upper rear cover (2 screws).
6.
Shift the jumper wire (JP401) on the AC drive
board from T401 to T402.
Note: Slide the terminal lock up to release the jumper
wire and slide it down to secure the wire in posi-
tion.
2-26
Advertisement
Chapters
Table of Contents
