Table of Contents
Advertisement
cess, counter-hold the quick-
release axle on the right side.
Quick-release axle in
telescopic forks
30 Nm
Tighten left axle clamping
screw 2 to specified torque.
Clamping screw for
quick-release axle in
telescopic fork
19 Nm
Tighten right axle clamping
screw 1 to specified torque.
Clamping screw for
quick-release axle in
telescopic fork
19 Nm
Remove the front-wheel
stand.
Position left and right brake
calipers on the brake discs.
Install securing screws 4 on
left and right and tighten to
specified tightening torque.
Radial brake caliper on
telescopic forks
38 Nm
Remove the adhesive tape
from the wheel rim.
WARNING
Brake pads not lying against
the brake disc
Risk of accident due to
delayed braking effect.
Before driving, check that
the brakes respond without
delay.
Operate the brake several
times until the brake pads are
bedded.
Insert the cable for the wheel
speed sensor into holding
clips 1 and 2.
Insert the wheel speed sensor
into the bore hole and install
screw 3.
193
Advertisement
Chapters
Table of Contents
