FAR FMP 7121 NA Manual page 69

ENGLISH
Removing the door from the oven (Fig.1)
° To simplify cleaning the interior of the
oven, the door can be removed.
° The process of removing the door is shown
below:
° Full open the door.
° Fold up the right and left side of locking
rod. (picture A)
° Close the door until reach to stop step,
hold on both left and right sides of the
door, then reclose the door, upward and
downward and pull out the door.
° The process of installing the door is shown
below:
° Accord to the opposite order of door
disassembly.
° When install oven door, make sure both
hinge plug into opening mouth directly.
° Both sides of hinge rabbet must bite up
each other.
° When open the door, spread down locking
rod(picture B)
EN 54
If the door drop accidently or hinges
shut up suddenly, do not push you hand
in hinges. Please call your after-sale
department.
FIG.1
Cleaning the glass door (Fig.2-5)
°
If possible, remove the oven door glass
following the manufacture's instructions.
Use warm water with a little detergent to
clean the glass sections of the door.
° Do not use abrasive products which could
damage the glass. Remember that if the
surface of the glass panel becomes
scratched, it could cause a dangerous
failure.
° To simplify the cleaning, the inner glass
panel can be taken out of the door. The
method for removing the glass from the
door is shown below. Install the glass use
the opposite steps like removed.
ENGLISH
EN 55