FAR FMP 7121 NA Manual page 52

ENGLISH
PROGRAM FUNCTIONS
1. Power on
Connect your appliance to the mains supply,
all indicator lights of the display board will
light up for 1second and then enter the clock
setting state. Default time show 12:00, hour
"12" flashes, the system clock setting icon
" " flashes, and the system clock icon "
is always on. The clock can be input at this
time, refer to clock setting requirement for
details.
• After 10 seconds without any operation
and the oven will enter to adjust minute
automatically.
• Within 10 seconds without any operation
when adjusting minute, the oven will enter
standby mode automatically.
• Under the standby mode, the display
always shows system time.(Refer to picture
3 for the display effect.)
Pic 3: Initial standby mode
EN 20
When the oven is powered on, the oven door
lock will start to self-inspection. During the
self-inspection, the door lock will run back
and forth automatically. If there is no
abnormal alarm within 20 seconds, then
self-inspection is completed. Or if it shows
fault code "E-3" during the self-inspection,
please refer to protection function for
problem analysis, you can touch "
"
cancel the fault code and return to standby
mode.
2. Time setting
In the standby mode, touching the "
button once to enter the system clock setting
state. At this time, the hour value of the
clock and the setting icon "
time) and the hour is set by rotating the
switch KB2. (0~23~0 is recyclable)
Pic 4: Hour and minute adjustment display effect
ENGLISH
" to
"
" flash (1s/1
EN 21