FAR FMP 7121 NA Manual page 58

ENGLISH
6.4 Forced unlocking: In the case of oven
lock, you can press and hold the "K2+K4"
button to unlock in the oven standby state.
When you hear the sound "Di" the door lock
is forced unlock, the door lock icon will be
extinguished. The door can be opened and
door lock function is disabled.
Note: After the oven door lock is forcibly
unlocked, the oven must be powered off and
re-powered. The door lock will be
self-tested after the power-on process, and
the oven can be used normally after self-test.
7. Error code & Solutions
7.1 Display will show E-1 if sensor is short
circuit or open circuit under cooking mode,
buzzer will continuously prompt for 10
times (1s/time), refer to display effect 10.
Oven will be locked at this time, touch "
button can return to standby mode.
Pic 10: Sensor abnormal alarm display effect
EN 32
7.2 When the temperature is below 35℃
after 5 minutes of heating(except for defrost
mode and Eco mode), it means the heating
element have a problem, display will show
E-2, buzzer will continuously prompt for 10
times(1s/time), refer to display effect
shown as pic 11.Touch "
return to standby status at this time.
7.3 During self-cleaning process, if display
screen shows fault code "E-3" when door is
locked into place, it means door lock or
detection circuit is faulty. When the fault
code appears, the buzzer will continuously
"
prompt for 10 times (1s/time), display effect
as below pic 12).Touch "
return to standby status.
" button can
Pic 11: Heat element abnormal
alarm display effect
" button can
Pic 12: Door lock abnormal alarm display effect
ENGLISH
EN 33