FAR FMP 7121 NA Manual page 53

ENGLISH
•
After adjusting the hours, re-touch "
to switch to minute adjustment. Minute
value and the setting icon "
time, you can set minute time by rotating
programming switch KB2.(0~59).
• After adjusting the minutes, re-touch the
" " to confirm, clock setting accomplished.
And at this time, the clock setting icon "
goes out and the second icon ":
(1s/1 time).
• When the hour and minute are set, the
system clock setting icon " " flashes and
the system clock icon "
After confirming, the setting icon " " is
off and the system clock icon "
to be displayed. In the hour setting, if you do
not touch the " " button to confirm within
10 seconds, it will automatically switch to
the minute setting. If the "
confirmed within 10 seconds after the clock
setting is completed, the system defaults to
complete the clock setting and automatically
returns to the standby state. If the clock is
not set within 20 seconds after power-on,
the system default clock is 12:00 and enters
standby state. If the power is turned off, the
clock will be reset.
EN 22
"
" flash at this
"
" flashes
" is always on.
" continues
button is not
"
•
In the standby state, only the system clock
is displayed.
3. The choices of function
• Under standby status, switch different
functions by rotating the programming
switch KB1 in turn, refer to picture 5 for the
order. (The oven will remember the last
operation)
Pic 5: Oven function mode
•
When selecting the function, the clock
position shows the default cooking time of
the corresponding function (it will show
"Eco" under Eco mode), the temperature
position shows the default temperature of
the corresponding function. For temperature
adjustable function mode, temperature place
will display default temperature value of
corresponding function and flash,
temperature icon "℃" will flash, and the
working parameter setting icon "
as well as the oven working icon "
ENGLISH
" flash
" is
EN 23