FAR FMP 7121 NA Manual page 49

ENGLISH
Electrical connection
Danger of electric shock!
Any electrical installation must be carried
out by an authorised professional.
• All fittings must be installed by a
competent person in accordance with local
regulations. If in doubt, consult a qualified
electrician.
• Important! Always switch off the
electricity supply at the mains during
installation and maintenance. We
recommend that the fuse is withdrawn or
circuit breaker switched off at the
distribution board whilst work is in progress.
• This product must be earthed if no earth
feed wire is available, consult an electrician.
• Means for disconnection must be
incorporated in the fixed wiring in
accordance with the wiring rules.
To achieve this install appropriate switched
fused connection unit.
• Note! A switched fused connection unit
having a contact separation of at least 3mm
in all poles should be connected in fixed
wiring.
EN 14
•
Connect the incoming positive, neutral
and earth cables to the terminals of the
switched fused connection unit. Ensure
connections are tight.
• The spur outlet must still be accessible
even when your oven is located in its housing
to enable the appliance to be disconnected
from the mains supply.
Cleaning
•
Always disconnect the power supply prior
to cleaning the appliance. If the switched
fused connection unit is difficult to reach,
shut off the power supply by using the
corresponding circuit breaker at the
distribution board.
• Clean the appliance thoroughly before
first use. The oven should be cleaned
regularly and any food deposits removed.
• Never clean the oven surfaces by steam
cleaning.
• The oven cavity should only be cleaned
with warm soapy water, using either a
sponge or soft cloth. No abrasive cleaners
should be used.
ENGLISH
EN 15