Table of Contents
Advertisement
Trouble Shooting
BURNER DOES NOT START
Burner
Check that the burner has not gone to lockout.
Causes of lockout can be:
No ignition. Electrode incorrectly positioned or insulation cracked, control box faulty.
No gas supply.
Poor combustion.
Flame probe in contact with ground, moisture
present on probe affecting insulation.
Live and Neutral connections reversed.
Inadequate ground control with flame.
General
For access to individual controls refer to section on Replacement Parts. For wiring continuity checks, refer to schematic
wiring layouts.
To check out the electrical wiring at the burner, you will first have to access the burner chamber. Use the following
procedure:-
1. Isolate the electrical power supply.
2. Open up the bottom burner access door. Remove door and put in a safe place.
3. Unscrew the 4 screws holding the inner panel in place and remove panel.
4. Unscrew the 3 screws holding the louvered base plate in place and remove plate.
The external mains connections are made to a terminal block situated in the center of the cooker under the oven. Re-
connect the electrical supply and check that there is a 110v power supply available across the mains input connections L
& N
on the terminal block. If not, then check connecting leads, fuse and whether power is available at mains plug. If power
S
is available across L
& N
S
, check for continuity across cooker overheat thermostat and flue safety device.
S
47
S
Advertisement
Table of Contents
