Table of Contents
Advertisement
Site requirements
Chimneys and vents shall terminate above roof level and in accordance with the requirement of the current issue of the
CAN/CGA - B149 Installation Code (Code W) (see Fig. 2) and be at least 1.53m (5ft) above the flue collar of the draft outlet.
1. If suitable, lined brick chimney is used it must be swept before connection and not less than 150mm (6in) internal
diameter.
2. The top of the chimney should be fitted with an approved terminal.
3. The flue route to the chimney should be as direct as possible. Resistance in the form of directional change should be
kept to a minimum. Right angle bends and horizontal runs should be avoided.
4. The chimney terminal should terminate at the highest possible point, preferably in a freely exposed position.
Termination at the roofs eaves is unacceptable.
5. The Aga Distributor or local gas company should be advised if there is any doubt as to the suitability of the flue.
6. Approved factory made chimneys are acceptable with the appliance and should not be less than 10mm (4in) internal
diameter.
7. In the event of an extractor fan being fitted in the vicinity of the range, compensatory ventilation will
satisfy the demands of the fan without influencing combustion efficiency or chimney flue condition.
110/120V 60 Hz 10 AMP FLEXIBLE CORD AND PLUG PARALLEL TYPE. When installed, the appliance must be
electrically grounded in accordance with local codes or, in the absence of codes, with National Electrical Codes
ANSI/NFPA 70.
An electrical socket must be provided within 6 feet of the LH side of the appliance and easily accessible to the user to
disconnect. Do not position socket above the appliance.
Take special care when cutting holes in wall or floor. Electrical wires may be behind the wall or floor covering and could
cause an electrical shock if you touch them.
Locate any electrical circuits that could be affected by the installation of this product and disconnect power circuit
This appliance is equipped with a (three-prong) grounding plug for your protection against a shock hazard and should
be plugged directly into a proper receptacle. Do not cut or remove the grounding prong from this plug.
Do not have a fuse in the neutral or grounding circuit. A fuse in the neutral or grounding circuit could result in electrical
shock.
Do not use an extension lead with this appliance.
Check with a qualified electrician if you are not sure the appliance is properly grounded.
Failure to follow these instructions could result in death or serious injury.
VENT CONNECTION (continued)
ELECTRICAL
WARNING
Electrical Grounding Instructions
10
be required to
Advertisement
Table of Contents
