Table of Contents
Advertisement
Replacement of parts (Burner)
The only parts to be replaced are:-
Electrodes
Electrode Leads
Control Box
If any other parts fails then the whole burner is to be
replaced.
ELECTRODES
See Fig. 23
1. Turn off power to appliance.
2. Unscrew the fixing screw and withdraw the
electrodes.
3. Carefully replace the electrodes, ensuring the gasket
is in place. Tighten screw.
CONTROL BOX
See Fig. 24
1. Turn off power to appliance.
2. Unplug 12-way connector.
3. Disconnect ignition lead, earth lead and ionization
lead.
4. Unscrew single fixing screw. Withdraw box.
5. Replace control box fixing screw and wires.
(Electrode Wires - See Page 34 , Fig. 20).
FIG. 23
FIG. 24
41
DESN 512443
DESN 512442
Advertisement
Table of Contents
