Re-Assemble - Heartland Classic HL-CKNG Owner's Manual

TO FIT NEW COOKER SAFETY OVERHEAT
THERMOSTAT & OVEN CONTROL THERMOSTAT
SEE FIG. 30
Follow instructions
COMPONENT ACCESS , Steps 1 to 6.
1. Undo the two screws on the front of the chassis
which holds the thermostat in place.
2. Remove the (2) push on connectors from back of
thermostat.
3. Open Roasting Oven door and, using a screwdriver,
loosen the rear fixing screws and remove the front
fixing screw of the inner L.H. oven side to expose the
thermostat phial.
4. Slacken the single screw where the phial passes
through the roasting oven side and rotate the cover
plate to open the access hole.
5. Slacken the single screw on the phial securing bracket
and rotate the cover plate.
6. Withdraw the capillary and phial from the oven.
7. Fit replacement thermostat and assemble in reverse
order.
To complete, follow instructions in 'RE-ASSEMBLE'.
Steps 1 to 5.
TO FIT NEW TIMER
Follow instructions
COMPONENT ACCESS', Steps 1 to 4.
1. Remove timer by depressing retaining clips.
2. Fit new timer ensuring correct location
To complete, follow instructions in section 'RE-
ASSEMBLE', Steps 2 to 5.

RE-ASSEMBLE

1. Locate the base of the control chassis into the bottom
of the doorway aperture, tilt the chassis backwards
into position and secure with the (4) screws.
2. Thread the wires for the cooker timer through the
aperture and connect them onto the rear of the cooker
timer fitted in the outer panel.
3. Refix the outer panel in position and secure with the
(2) screws.
4. Replace the thermostat knob.
5. Replace the controls door.
Replacement of parts (Electrical Controls)
in section ELECTRICAL
in section 'ELECTRICAL
OVERHEAT
THERMOSTAT
COOKER
THERMOSTAT
FIG. 30
44
THERMOSTAT
PHIALS LOCATION
DESN 511738 A
DESN 510546