Installation requirements
SITE LOCATION
1. Check that the hearth is level, then remove the
appliance from its transit wooden pallet, and position
it with its back against the wall and in its intended
position for flue connection.
2. Locate and fit flue pipe into socket of flue pipe
adaptor, seal joint with rope and fire cement.
3. Connect and terminate the flue system in accordance
with the regulations in force.
Connect the relevant services to the appliance:
1.
Gas
2.
Electric
3.
Flue Pipe
SETTING COMBUSTION
Because this appliance uses a pre-mix burner, no setting
up of combustion is required; the burner automatically
controls the air to gas rate ratio.
12