TechniSat DIGITRADIO 586 Manual page 72

> Change the value with the  or  buttons and then press OK.
This preset can be retrieved at any time in My EQ.
18.2 Internet settings
> Press the MENU button and then select [Main Menu > System Settings >
Internet Settings].
In this menu you will find some settings and information about the Internet
connection.
> Select Network wizard to establish a WLAN connection.
The network wizard shows you all the WLAN stations within range. Use
the / and OK buttons to select the WLAN network you recognise and
enter the password using the displayed keyboard. Then select
press the OK button. If the password entered is correct, a connection to
the network is now established. The signal bars
display indicate whether a connection exists.
To cancel the input, select
mistake, you can delete the last letter you entered by pressing
> If you want to establish a WPS connection instead of entering the password,
proceed as follows after selecting the WLAN network:
How you activate WPS on your router can be taken from its instruction
manual.
> Select [Press button] on the DIGITRADIO 586 after selecting the WLAN
network. Take note of the instructions on the display.
> Start WPS on your router by pressing the relevant button.
> If your router only supports the WPS PIN, select [PIN] on the DIGITRADIO
586 and take note of the PIN shown on the display. You then need to enter
the PIN in the router.
18.2.1 WPS connection
> Select [Internet settings > PBC WLAN set up] if your router has the WPS
function. This establishes a direct connection to the router without having to
enter the - WLAN password.
How you activate WPS on your router can be taken from its instruction
manual.
> Start WPS on your router by pressing the relevant button. Note the
Instructions on the DIGITRADIO 586 display.
72
and press the OK button. If you make a
in the status bar of the
and
.