Troubleshooting - Leadshine Technology CS-D507E User Manual

USB to RS232 conversion, contact your supplier or Leadshine for such a cable with part number
has been verified working fine.
CABLE-PC-1
(RS232 tuning cable)

12. Troubleshooting

If your drive does not operate properly, the first step is to identify whether the problem is electrical or mechanical in
nature. The next step is to isolate the system component that is causing the problem. As part of this process you may
have to disconnect the individual components that make up your system and verify that they operate independently. It
is important to document each step in the troubleshooting process. You may need this documentation to refer back to at
a later date, and these details will greatly assist our Technical Support staff in determining the problem should you need
assistance.
Many of the problems that affect motion control systems can be traced to electrical noise, controller software errors, or
mistake in wiring.
Symptoms
Motor is not rotating
Wrong motor rotation direction
The drive in fault
(USB to RS232 Conversion Cable)
Possible Problems
No power
Microstep resolution setting is wrong
Fault condition exists
The drive is disabled
The Direction signal level is reverse
Red light flashes once in a 5-second
period
Red light flashes twice in a 5-second
period
Red light flashes 4-times in a 5-second
period
Red light flashes 7-times in a 5-second
period
CS-D507E Closed Loop Stepper Drive User Manual
USB2.0-232
USB2.0-232
Solutions
Connect power supply correctly
Setting appropriate microstep
Check wiring and restart power
Drive restore factory setting, and keep
ENA+, ENA- input signals unconnected.
Toggling the SW5 DIP switch
The motor coil may short circuit or exiting
the wrong wiring
The power supply exceeds Max. operation
voltage
Motor wiring poor contact, or motor
wiring wrong
If using Leadshine's motor, maybe motor
wiring poor contact; If using 3
which
rd motor,
Page | 14