Led Light Indication; Motor Selection; Power Supply Selection - Leadshine Technology CS-D507E User Manual

CS-D507E Closed Loop Stepper Drive User Manual
CS-D507E has a tuning port with RS232 to modify the drive parameters, it is just used to modify parameter, not for
equipment control because neither precision nor stability is sufficient. If you need a field bus drive, use a Leadshine
RS485 or EtherCAT type drives
The interface definition is as follows:

3.6 LED Light Indication

There are two LED lights for CS-D507E, one red and one green. The GREEN one is the power indicator which will be
always on generally. The RED one is a protection indicator. It is off always when a CS-D507E operates normally, but
will flash 1, 2 or 7 times in a 5-second period when error protection is enabled. Different number of flashes indicates
different protection type (read Section 9).

4. Motor Selection

The CS-D507E is designed to power 2-phase (or 4-phase 0.9 degree) NEMA 17/23/24 stepper motors under 10000-line
incremental encoders (recommend 1000-line). Leadshine offers many high-performance stepper motors compatible
with the CS-D507E which you can find in the Appendix A of this document. The CS-D507E can also power similar
stepper motors with incremental encoders from third-party suppliers.
Notes: Contact Leadshine for stepper motor with 2000-line, 2500-line, 5000-line encoders.

5. Power Supply Selection

The CS-D507E can power small and medium size closed loop stepper motors (frame size from NEMA17 to 24) from
Leadshine (see Appendix A) or other motor manufacturers. To get good system performance, it is important to select
proper supply voltage and output current. Generally speaking, supply voltage determines the high speed performance
of the motor, while output current determines the output torque of the driven motor (particularly at lower speed).
Higher supply voltage will allow higher motor speed to be achieved, at the price of more noise and heating. If the
motion speed requirement is low, it's better to use lower supply voltage to decrease noise, heating and improve
reliability.
Notes: See Appendix B at the end of this document for Leadshine CS-D507E compatible switching power supplies
specially designed for stepper & servo controls.
Page | 8