Table of Contents
Advertisement
Blink
Sequence wave of red LED
time(s)
0.2S
1
0.3S
0.2S
2
3
4
5
6
0.2S
0.3S
7
Always
When above protections are active, the motor shaft will be free or the red LED blinks. Reset the drive by repowering it
to make it function properly after removing above problems.
10. Software Configuration
The CS-D507E is designed for simple setup and implementation. For most applications, no software configuration or
tuning is needed especially when driving Leadshine stepper motors with encoders (see Appendix A). If you want to do
fine tuning or custom configurations such as micro-step, current percentage change..., you can use Leadshine's free
MotionStudio software to make the changes.
11. Accessories
If you plan to use the Leadshine software, contact your supplier or Leadshine to purchase the RS232 cable with part
number
CABLE-PC-1
for connecting the CS-D507E to a computer with Windows 7/8/10 installed. In the case of using
5S
Over-current
5S
Over-voltage
Chip error
Fail to lock motor
shaft
EEPROM error
Fail to auto tuning
5S
Position following
error
PCB board is
-
burned out
CS-D507E Closed Loop Stepper Drive User Manual
Description
Turn off the power immediately.
a) Check wiring is short-circuited or not;
b) Check motor is short-circuited or not.
Turn off the power immediately.
a) Check if the power voltage is higher
than 90VDC
Restart the power supply, if the drive is
still alarm, please contact after-sale
a) The drive is not connected to a motor.
b) If alarm is occurred when connect a
motor, please check the motor wiring.
Restart the power supply, if the drive is
still alarm, please contact after-sale
Disable auto-tuning function by
Leadshine MotionStudio software
a) The value of position following error
is set too small.
b) Motor torque is not enough, or motor
speed is too high.
c) Motor wiring error, check wiring
Contact after-sale
a) Power supply connection is wrong
Trouble shooting
Page | 13
Advertisement
Table of Contents
