Contents Contents Table of Contents Dynamic current setting ................9 Standstill current setting................9 1. Introduction, Features and Applications..............1 8. Wiring Notes ......................10 Introduction ......................1 9. Typical Connection....................10 Features ......................... 1 10. Sequence Chart of Control Signals ............... 11 Applications ......................
Avoid dust, oil fog and corrosive gases Environment 0 ℃ - 50 ℃ (32℉ - 122℉) The M880A is a high performance microstepping driver based on pure-sinusoidal current control Ambient Temperature technology. Owing to the above technology and the self-adjustment technology (self-adjust current 40%RH -...
The M880A can accept differential and single-ended inputs (including open-collector and PNP DIR signal: In single-pulse mode, this signal has low/high voltage levels, output). The M880A has 3 optically isolated logic inputs which are located on connector P1 to accept representing two directions of motor rotation; in double-pulse mode (set by DIR+ line driver control signals.
5. Connecting the Motor motors should be run at only 70% of their rated current to prevent over heating. The M880A can drive any 2-pahse and 4-pahse hybrid stepping motors. Connections to 4-lead Motors 4 lead motors are the least flexible but easiest to wire. Speed and torque will depend on winding Figure 7: 6-lead motor full coil (higher torque) connections inductance.
6. Power Supply Selection 7. Selecting Microstep Resolution and Driver Output Current The M880A can match medium and small size stepping motors (from NEMA frame size 17 to 43) made by Leadshine or other motor manufactures around the world. To achieve good driving This driver uses an 8-bit DIP switch to set microstep resolution, and motor operating current, as performances, it is important to select supply voltage and output current properly.
M880A Microstepping Driver Manual V1.0 M880A Microstepping Driver Manual V1.0 current. 2000 4000 The current automatically reduced to 60% of the selected dynamic current one second after the last 5000 pulse. Theoretically, this will reduce motor heating to 36% (due to P=I *R) of the original value.
M880A Microstepping Driver Manual V1.0 M880A Microstepping Driver Manual V1.0 10. Sequence Chart of Control Signals Short Circuit Protection In order to avoid some fault operations and deviations, PUL, DIR and ENA should abide by some Protection will be activated in case of short circuit between motor coils or between motor coil and rules, shown as following diagram: ground.
Please include a written description of the problem along with contact name and address. Send failed product to distributor in your area or: Leadshine Technology Co., Ltd. 3/F, Block 2, Nanyou Tianan Industrial Park, Nanshan Dist, Shenzhen, China. Also enclose information regarding the circumstances prior to product failure.